Avanti Refrigerators ERROR CODES

Avanti’s compact refrigerators have served me well in terms of cooling performance and space-saving design. However, I did face some difficulty when the freezer compartment developed frost buildup faster than expected. Avanti’s customer service was responsive and guided me on how to defrost the freezer properly, which resolved the issue. While this was a minor inconvenience, it would be helpful if Avanti’s products were more foolproof in their operation.

Issue: Beverage Cooler does not operate

Possible Solution(s): Not plugged in. The appliance is turned off. The circuit breaker tripped or a blown fuse.

Issue: Beverage Cooler is not cold enough

Possible Solution(s): Check the temperature control setting. The door is opened too often. The door is not closed completely. The door gasket does not seal properly.

Issue: Turns on and off frequently

Possible Solution(s): The room temperature is hotter than normal. A large amount of contents has been added to the Beverage Cooler. The door is opened too often. The door is not closed completely. The temperature control is not set correctly. The door gasket does not seal properly.

Issue: The light does not work

Possible Solution(s): Not plugged in. The circuit breaker tripped or a blown fuse. The light button is “OFF”.

Issue: Vibrations

Possible Solution(s): Check to assure that the Beverage Cooler is level.

Issue: The Beverage Cooler seems to make too much noise

Possible Solution(s): The rattling noise may come from the flow of the refrigerant, which is normal. As each cycle ends, you may hear gurgling sounds caused by the flow of refrigerant in your Beverage Cooler. Contraction and expansion of the inside walls may cause popping and crackling noises. The Beverage Cooler is not level.

Issue: The door will not close properly

Possible Solution(s): The door is misaligned. The Beverage Cooler is not level. The gasket is dirty. The shelves are out of position.

Issue: Display flashes Error message “EO”

Possible Solution(s): Connection failure – there is a wire or component that is not connected correctly.

Issue: Display flashes Error message “E1”

Possible Solution(s): Temperature sensor failure.

Issue: Display flashes Error message “E2”

Possible Solution(s): Defrost sensor (Coil Sensor) failure.

Issue: Display flashes Error message “HH” or  “LL”

Possible Solution(s): Temperature of inner cabinet is over 99°F / 37°C Temperature of inner cabinet is under 32°F / 0°C