The brewing unit is the mechanism into which the capsule is inserted. It retains it and perforates it when the lever is lowered, which allows water to pass through the capsule.
The brewing unit may be at fault if you observe that your coffee:
- flows into the drip tray rather than the cup,
- seems less creamy and clearer.
The brewing unit is located on the upper part of the device.
Magimix coffee makers are renowned for their quality and versatility, but like all appliances, they may require maintenance and part replacements over time. One such essential component that might need to be replaced is the brewing unit. The brewing unit plays a vital role in the coffee-making process as it’s where the coffee is brewed before being dispensed into your cup.
Changing the brewing unit of a Magimix coffee maker is an advanced task that should be approached with care. Here’s a step-by-step guide to assist you through the process.
Materials Needed:
- A new Magimix brewing unit
- A screwdriver (depending on your model)
- A soft cloth
- A user manual specific to your Magimix model
Procedure:
Step 1: Turn Off and Unplug the Coffee Maker
Always prioritize safety. Make sure to turn off the coffee maker and unplug it from the wall socket. Allow the machine to cool down if it was recently used.
Step 2: Consult Your User Manual
Every Magimix coffee maker model might have slightly different construction, so it’s vital to consult the user manual for specific instructions on removing and replacing the brewing unit.
Step 3: Open the Service Door or Side Panel
Most Magimix models will have a service door or side panel providing access to the internal components. This may be secured with screws or clips, depending on the model, so have a screwdriver handy if needed.
Step 4: Remove the Old Brewing Unit
Once you have access to the internal components, locate the brewing unit. It’s usually near the center of the machine. Carefully disconnect any attached components or clips, being mindful of how they are connected for reassembly later. Then, gently slide or lift the brewing unit out of its position.
Step 5: Clean the Area
Wipe the area where the brewing unit was located with a soft cloth to remove any coffee grounds or residue. Ensuring this area is clean will help the new brewing unit fit properly and function efficiently.
Step 6: Install the New Brewing Unit
Take your new brewing unit, and carefully place it into the position where the old one was located. Make sure it aligns properly with any connectors or clips. Reattach any components that were disconnected earlier.
Step 7: Close the Service Door or Side Panel
Once the new brewing unit is installed correctly, close the service door or side panel. Reinsert and tighten any screws if necessary.
Step 8: Plug in the Coffee Maker and Run a Test Cycle
After everything is reassembled, plug the coffee maker back in, and turn it on. It’s advisable to run a test cycle with water only, without coffee, to ensure that everything is working correctly.
Conclusion
Changing the brewing unit of a Magimix coffee maker can seem intimidating, but with careful attention to detail and adherence to the specific instructions in your user manual, it’s a task that can be accomplished. If you feel uncomfortable performing this task yourself, consider seeking professional assistance, as improper handling could void your warranty or cause damage to the machine.
Regular maintenance and timely replacement of parts like the brewing unit will ensure that your Magimix coffee maker continues to serve up delicious, freshly brewed coffee for years to come. Enjoy the renewed taste and functionality of your coffee maker!
