Loading

How to Clean the Lint Filter of a Dryer

Jul 25, 2023, 16:15pm

The clothes dryer is a complementary household appliance to the washing machine, which works on an internal heating system to dry clothes.

The air which is sucked in from the outside by a turbine is then heated by the resistors of the dryer. The moist air turns into water which is finally stored in a collection tank.

With this hot and humid air also circulate lint and dust from textiles. Hence the essential role of a lint filter. Like any other device, it is therefore important to ensure that all its parts are always in good condition.

The fluff filter plays a major role since it recovers most of the textile fibers collected during the drying cycle.

With time and use, this filter accumulates a lot of textile fibers, and no longer performs its function correctly. Hence the need to maintain it regularly. If it happens that the filter deteriorates, it must be replaced.

When cleaning such an accessory under water, care must be taken to let it dry thoroughly before putting it back in place. Since the operation is simple, you can do it by yourself.

For most models, the lint filter is located at the entrance of the appliance, at the edge of the dryer drum.

A crucial part of maintaining your dryer’s efficiency and safety involves regularly cleaning its lint filter. The lint filter, or lint trap, captures lint produced during the drying cycle, preventing it from clogging your dryer’s exhaust system and reducing the risk of a fire. This article will guide you through the process of effectively cleaning your dryer’s lint filter.

How to Clean the Lint Filter of a Dryer

Tools You Might Need:

  1. Vacuum cleaner with a brush attachment
  2. Soft brush (an old toothbrush will do)
  3. Warm, soapy water

Step-by-Step Guide:

Step 1: Locate the Lint Trap

The first step is to locate the lint trap. It’s typically found inside the dryer’s drum, along the top edge, or at the bottom of the door opening. If you’re unsure where it’s located, refer to your dryer’s user manual.

Step 2: Remove the Lint Trap

Carefully pull out the lint trap. It should slide out easily. However, avoid forceful tugging, as this can cause damage.

Step 3: Clean off the Lint

Remove the lint from the screen by hand. It’s best to do this over a trash can or bag to minimize mess.

Step 4: Use a Vacuum

Use a vacuum cleaner with a brush attachment to remove any lint that’s stuck in the screen. Be sure to vacuum both sides of the screen and around the edges.

Step 5: Wash the Lint Trap

For a thorough cleaning, especially if you notice a residue buildup (which can be caused by dryer sheets), wash the lint trap. Fill a basin or sink with warm, soapy water. Submerge the lint trap and gently scrub it with a soft brush to remove the residue.

Step 6: Rinse and Dry

Rinse the lint trap thoroughly under warm running water. Ensure all the soap suds are removed. Shake off the excess water and let it air dry completely. It’s crucial the lint trap is thoroughly dry before it’s replaced to prevent rust or damage to the dryer.

How to Clean the Lint Filter of a Dryer

Step 7: Clean the Lint Trap Housing

While the lint trap is drying, use your vacuum’s nozzle attachment to clean the lint trap housing in the dryer. This will remove any remaining lint that could potentially block the vent.

Step 8: Replace the Lint Trap

Once the lint trap is completely dry, slide it back into the slot. Make sure it’s properly seated.

In conclusion, regularly cleaning your dryer’s lint filter is a simple but essential task to keep your dryer running efficiently and safely. Ideally, you should remove lint after each drying cycle. A thorough cleaning, as described in the steps above, should be done every few months or when you notice a buildup of residue that might hinder airflow. Not only will this practice extend the life of your dryer, but it will also help to prevent potential fire hazards.